[SunHELP] RE:Sparc 20 is not bootable...

[sunhelp at sunhelp.org]

 It sounds pretty obvious that you're trying to boot off of the wrong disk. Try booting
off
of the Seagate hard-drive. 

 Also, what was your reasoning for performing the "set-defaults" command? By doing
that you just eliminated any customization of the OBP environment that was
previously done.

> > <#0> ok probe-scsi-all
> 	/iommu at f,e0000000/sbus at sbusf,e0001000/dma at 3,81000/esp at 3,80000
> 	/iommu at f,e0000000/sbus at sbusf,e0001000/dma at 1,81000/esp at 1,80000
> 	Target 1
> 	Unit 0 Disk SEAGATE ST/312000(and so on...)
> 	Target 3
> 	Unit 0 Disk FUJITSU M2952ESPSUN2.1G(and so on...)

> > -----Original Message-----
> > Behalf Of LLamas-Higueras, Javier
> > but yesterday after we did a password change we decided to reboot
> also the
> > machine. The problem is that the machine can NOT be bootable since
> this
> > reboot.
> > 
> > My messages are the following:
> > ....
> > <#0> ok set-defaults
> > .....
> > <#0> ok boot
> > Robooting with command:
> > Boot device: /iommu/sbus/espdma at f,4000001/esp at f,800000/sd at 3,0 File
> and
> > args:
> > bootblk: cant find the boot program
> > Program terminated

> > ...
> > <#0> ok sync
> > No callback routine has been installed

   From what it sounds like you're doing, this sounds
normal.

> > <#0> ok boot cdrom
> > (wait a few seconds \ )
> > Level 15 interrupt

 Sounds like your cd is corrupted.

 -david