[rescue] PIX-ish ATX cases?

[Kay]

hey ... i thought (According to cisco's web site) that 5.1(5) was the latest
that runs on 2mb of flash???

according to 5.2(1) release notes , it requires 16 megs of flash..

regards


>   The LDIR 2mb Flash card will only run PIX OS < 6.0.  To run 6.0 and
above
> code you need the 16MB flash card.  As for the serial number, you will
need to
> use it to generate the activation key/license.  PIX OS is tied to the
serial
> number of the device as well as the license keycode you buy.  Supposedly
there
> is a way to set the serial number on the flash card...but I don't know how
to
> do that.  Also, the LDIR motherboard is not quite the same as the PIX
mother-
> board...it's a slightly older model and PIX 6.0 code will complain that it
is
> not designed to run on that motherboard (I actually found that to occur on
a
> PIX 515 I have in the lab -- other engineers were going to scrap it
because
> they thought the motherboard was bad since it kept rebooting complaining
about
> the motherboard after they upgraded it to 6.3(3)...so now I have it
running
> 5.3 code and it works fine).
>
> Ido
> -- 
>
============================================================================
===
> Ido Dubrawsky, CISSP           E-mail:          ido at dubrawsky.org
> Network Security Architect
> dubrawsky.org
> 500 Hermleigh Rd
> Silver Spring, MD. 20902
> (301) 651-5441 (cell)
>
============================================================================
===
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue