WG: [SunHELP] How to get the OK prompt on Netra T1

Stefan Auweiler Stefan.Auweiler at saitc.de
Mon Sep 1 00:36:05 CDT 2003


After getting some hints, I should point out:

1. I do get the lom> prompt. So it seems that the serial line is OK.
2. after powering on (using the switch con the back or 'poweron' in lom) I
do get the 'LOM event ...' message.
3. there is nothing more, until I decide to switch the box off or type '#.'
and say 'poweroff'.

I'm missing any console message or the ability to stop the box from booting.
Even removing the disks - I thought should bring up an OK prompt or anything
telling me that there is something going wrong.

Are there any ideas, what to try?

Regards
Stefan Auweiler



> -----Urspr|ngliche Nachricht-----
> Von: sunhelp-bounces at sunhelp.org
> [mailto:sunhelp-bounces at sunhelp.org] Im Auftrag von Stefan Auweiler
> Gesendet: Montag, 1. September 2003 01:01
> An: sunhelp at sunhelp.org
> Betreff: [SunHELP] How to get the OK prompt on Netra T1
>
>
> Hello,
>
> I'm new to this list and new to my Netra T1 105.
> I got it from ebay and want to install a new solaris 9 on it.
> I read the online documentation and lots of googles. Nothing helped.
>
> Here are my probs:
> Using a serial link to my Windows HyperTerminal, I get the
> LOM> prompt. 'poweron' will hide the 'lom>' prompt, which
> should mean, that I'm now on the console prompt. But there is
> nothing more. I can go back to 'lom>' using '#.' and back
> again to the 'console'. But I will never get the 'OK' prompt
> and can not send the break signal ('ctrl-break' on my pc).
>
> Therefore, I can not issue the 'boot cdrom' command ;-((
>
> What I'm doing wrong?
>
> Regards
> Stefan
> _______________________________________________
> SunHELP maillist  -  SunHELP at sunhelp.org
> http://www.sunhelp.org/mailman/listinfo/sunhel> p



More information about the SunHELP mailing list