[SunHELP] configuring 2 nic on one system

Ismail Shafi sunhelp at sunhelp.org
Fri Sep 28 14:33:33 CDT 2001


no both of the cards were installed before
installation
so .. & cause the installation program gives only one
card to configure...

thanks
ismail
--- John_Kennedy <jckennedy at agere.com> wrote:
> After you installed the 2nd card did you do a boot
> -r to reconfigure
> your devices???
> If not the system will know it exists but not know
> what it is...
> John
> 
> 
> Ismail Shafi wrote:
> > 
> > Hello all
> > 
> >  I have 2 ethernet cards on a single system
> >  one card i configured during setup which is
> working
> > alright .
> >  but the other card which is also a ISA card ...
> >  but when i try to configure it with ifconfig it
> says
> > no such device...
> > 
> > but it is detecting it .. in the dmesg it shows
> > 
> > ISA - device : elx0
> > elx0 is /isa/elx at 1 , 300
> > 
> > which file i have to edit in order to chage my ip
> > permently
> > 
> > thanks
> > ismail
> > 
> > __________________________________________________
> > Do You Yahoo!?
> > Listen to your Yahoo! Mail messages from any
> phone.
> > http://phone.yahoo.com
> > _______________________________________________
> > SunHELP maillist  -  SunHELP at sunhelp.org
> > http://www.sunhelp.org/mailman/listinfo/sunhelp
> _______________________________________________
> SunHELP maillist  -  SunHELP at sunhelp.org
> http://www.sunhelp.org/mailman/listinfo/sunhelp


__________________________________________________
Do You Yahoo!?
Listen to your Yahoo! Mail messages from any phone.
http://phone.yahoo.com



More information about the SunHELP mailing list