[SunHELP] Urgent ! - VLAN 802.1q

[Chanaka Mendis]

Alex Shavkun wrote:

> Hello.
>
> > "Sangbutsarakum, Patai" wrote:
> >
> > > Dear guru
> > > Now my E250 use Fast Ethernet [hme]. If I need to plug this interface with
> > > Cisco 2924, then set VLAN on that switch.
> > > Does my SUN Fast Ethernet support VLAN [IEEE 802.1q] ?
> > > If support, what I have to do with my Solaris 2.6 or anything?
> > > If not, what kind of card that I must use to support 802.1q?
> > >
> > > Thanks in advance
> > > Patrick
> >
> > Hi,
> > You dont have to do anything on SUN . Just configure VLAN on 2924.
> >
> > /Gyanatha
>
> I just doing follow:
>
> Cisco:
>
> interface FastEthernet0/8
>  switchport trunk encapsulation dot1q
>  switchport mode trunk
>  no cdp enable
>
> SUN:
>
> Is it realy I dont have to do anything on SUN? What about to add more one
> interface for VLAN.
>
> Bye.
> Alex.
>
> ----------------------
> Altai State University
>    Internet Center
> e-mail: sae at dcn-asu.ru
> tel   : +7 3852 220202
> fax   : +7 3852 367423
> _______________________________________________
> SunHELP maillist  -  SunHELP at sunhelp.org
> http://www.sunhelp.org/mailman/listinfo/sunhelp

Hi Alex,
>From this mail, What I understood is  you are trying to do something like
trucking. Is that So?
If so You need to install Sun truncking software and then you have to configure
it on SUN. ( You need more than one interface)

/Gayantha