[Sunhelp] On-board Ultr 5 hme0 not working

[Mike Gracy (Ghost Rider)]

Did you run diags from Open Boot?  Look at the system variable
'tpe-link-test?' and make sure it is set to true, false is equivalent to
turning off the interface.  You can also try Stop-N from the OK prompt to
reset the nvram to factory defaults failing everything else.

Mike Gracy
mgracy at xuma.com
-----Original Message-----
From: The XUMA Ghostrider mailing list
[mailto:GHOSTRIDER at LISTSERV.XUMA.COM]On Behalf Of Kalusniak, Jeff
Sent: Thursday, November 09, 2000 12:38 PM
To: GHOSTRIDER at LISTSERV.XUMA.COM
Subject: [Sunhelp] On-board Ultr 5 hme0 not working


It's possible that we've got a refurbished dud, but.....

I have an Ultra 5 that the on--borad hme seems to be dead.  If I cable it to
the hub and introduce power, no link light.

All the others show link immediately (as they should).

Any ideas?  Or is this just a bad board?

Thanks

Jeff Kalusniak
Goliath Falls Inc.


_______________________________________________
SunHELP maillist  -  SunHELP at sunhelp.org
http://www.sunhelp.org/mailman/listinfo/sunhelp