[rescue] openbsd and scsi drives...

[Stephen Sukovich]

>It sounds like the E150 has a second SCSI controller that may not be
>supported
>by OpenBSD - the "Differential Ultra/Wide SCSI (UDWIS/S)" didn't appear
to >be
>on the OpenBSD/SPARC page as compatible (see:
>http://www.openbsd.org/sparc.html#hardware), but I didn't look too
hard...

im not using a differential ultra wide scsi controller. It's a sun sbus
sunswift Ethernet+scsi card which is a fas366 chipset card and that's
supported.

SCSI Host Adapters 
SBus NCR53c9x adapters (esp) 
->>> SBus 10/100Mbit SunSwift Ethernet+SCSI cards, aka HME + FAS366
cards (esp) 
SBus Qlogic adapters (isp) 
PCI NCR53c8xx adapters (siop)


>Also, the E150 wasn't listed as either supported or unsupported under
>http://www.openbsd.org/sparc64.html#hardware...

well essentially from what I understand an e150 is an ultra1 motherboard
without the upa creator card. It looks like an ultra 1 motherboard with
an extra sbus slot in the upa slot spot. Basically the scsi cage is
connected from the cage to the fas366 scsi port with an external cable
which I don't understand why they have it this way. I may try using one
of my 50-ping to 68-pin cables and connecting it from the onboard
controller and seeing if all the drives show up then.

I thought maybe this was some unix-fu that I don't understand about
configuring scsi drives or just don't know yet. Since ive normally only
used at most 2 drives in a system before. Except that time I had 3 but 2
where in raid and just looked like 1 drive to the OS. 

>dmsg output?

Ok ill have the dmesg in a second....   

Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights
reserved.
Copyright (c) 1995-2003 OpenBSD. All rights reserved.
http://www.OpenBSD.org

OpenBSD 3.4 (PANTHERDEN) #3: Thu Feb 26 19:37:08 EST 2004
    root at pantherden.dencage.com:/sys/arch/sparc64/compile/PANTHERDEN
total memory = 134217728
avail memory = 116908032
using 819 buffers containing 6709248 bytes of memory
bootpath: /sbus at 1f,0/espdma at e,8400000/esp at e,8800000/sd at 0,0
mainbus0 (root): Sun Ultra 1 SBus (UltraSPARC 167MHz)
cpu0 at mainbus0: SUNW,UltraSPARC @ 167 MHz, version 0 FPU
cpu0: physical 32K instruction (32 b/l), 16K data (32 b/l), 512K
external (64 b/l)
timer0 at mainbus0 addr 0xfffc3c00 irq vectors 7f0 and 7f1
sbus0 at mainbus0 addr 0xfffcc000: clock = 25 MHz
STC0 on /mainbus enabled
DVMA map: ff800000 to ffffe000
IOTDB: 107c6000 to 107c8000
SUNW,CS4231 at sbus0 slot 13 offset 0xc000000 vector 24 ipl 13 not
configured
auxio0 at sbus0 slot 15 offset 0x1900000
flashprom at sbus0 slot 15 offset 0x0 not configured
SUNW,fdtwo at sbus0 class block slot 15 offset 0x1400000 vector 29 ipl
11 not configured
clock0 at sbus0 slot 15 offset 0x1200000: mk48t59: hostid 8083231f
zs0 at sbus0 slot 15 offset 0x1100000 vector 28 ipl 12 softpri 6
zstty0 at zs0 channel 0 (console i/o)
zstty1 at zs0 channel 1
zs1 at sbus0 slot 15 offset 0x1000000 vector 28 ipl 12 softpri 6
zskbd0 at zs1 channel 0: reset timeout
zskbd0: no keyboard
zstty2 at zs1 channel 1, mouse
uperf0 at sbus0 slot 15 offset 0x1300000: model SUNW,sc-up (0/0) ports 3
SUNW,pll at sbus0 slot 15 offset 0x1304000 not configured
dma0 at sbus0 slot 14 offset 0x8400000: dma rev 2
esp0 at dma0 slot 14 offset 0x8800000 vector 20 ipl 3: ESP200, 40MHz,
SCSI ID 7
scsibus0 at esp0: 8 targets
sd0 at scsibus0 targ 0 lun 0: <SEAGATE, ST32171W SUN2.1G, 7462> SCSI2
0/direct fixed
sd0: 2029MB, 2735 cyl, 19 head, 80 sec, 512 bytes/sec, 4157201 sec total
cd0 at scsibus0 targ 6 lun 0: <TOSHIBA, XM5701TASUN12XCD, 0297> SCSI2
5/cdrom removable
ledma0 at sbus0 slot 14 offset 0x8400010: dma rev 2
le0 at ledma0 slot 14 offset 0x8c00000 vector 21 ipl 6: address
08:00:20:83:23:1f
le0: 8 receive buffers, 2 transmit buffers
SUNW,bpp at sbus0 slot 14 offset 0xc800000 vector 22 ipl 2 not
configured
hme0 at sbus0 slot 0 offset 0x8c00000 vector 4 ipl 6: address
08:00:20:83:23:1f
nsphy0 at hme0 phy 1: DP83840 10/100 media interface, rev. 0
esp1 at sbus0 slot 0 offset 0x8800000 vector 3 ipl 3: dma rev fas
esp1: FAS366/HME, 40MHz, SCSI ID 7
scsibus1 at esp1: 8 targets
sd1 at scsibus1 targ 2 lun 0: <SEAGATE, ST34371W SUN4.2G, 7462> SCSI2
0/direct fixed
sd1: 4094MB, 3882 cyl, 16 head, 135 sec, 512 bytes/sec, 8385121 sec
total
sd2 at scsibus1 targ 3 lun 0: <SEAGATE, ST32550W SUN2.1G, 0418> SCSI2
0/direct fixed
sd2: 2048MB, 3511 cyl, 11 head, 108 sec, 512 bytes/sec, 4194995 sec
total
sd3 at scsibus1 targ 4 lun 0: <SEAGATE, ST32550W SUN2.1G, 0418> SCSI2
0/direct fixed
sd3: 2048MB, 3511 cyl, 11 head, 108 sec, 512 bytes/sec, 4194995 sec
total
sd4 at scsibus1 targ 5 lun 0: <SEAGATE, ST32550W SUN2.1G, 0418> SCSI2
0/direct fixed
sd4: 2048MB, 3511 cyl, 11 head, 108 sec, 512 bytes/sec, 4194995 sec
total
pcons at mainbus0 not configured
root on sd0a
rootdev=0x700 rrootdev=0x1100 rawdev=0x1102
pantherden#

Stephen Sukovich