[rescue] Ultra 2 Power

[Eric Dittman]

> > Is there a way to configure an Ultra 2 to come back on after
> > a power failure?
> 
> all the "smart" power supplied (starting with the sparc5/20 and above) remember
> what their previous state was before losing power.  if they were off, they
> stay off, if they were on, the power back on.  if yours doesn't do this there
> may be something wrong with your power supply, unless there is a way to
> over-ride this behavior that i am unaware of.

I actually haven't lost power yet, I just wanted to know for
later since the switch is momentary.
-- 
Eric Dittman
dittman at dittman.net
Check out the DEC Enthusiasts Club at http://www.dittman.net/