[SunHELP] Failback manualy with IP MultiPathing

[Fogg, James]

Take both interfaces out of multipathing, set them up on the same net, and
only connect one. Move cable to other when in need.

OK, not the best solution, I admit.

Actually, you could do this, and connect both ports. Then admin-down one of
the switchports or down the port in Solaris.

~ -----Original Message-----
~ From: jalal.fariat at mpsa.com [mailto:jalal.fariat at mpsa.com]
~ Sent: Thursday, December 13, 2001 6:17 AM
~ To: sunhelp at sunhelp.org
~ Subject: [SunHELP] Failback manualy with IP MultiPathing
~ 
~ 
~ Hi all,
~ 
~ With solaris 8 (07/01), I configure a MultiPathing group of 
~ two interfaces
~ (eri0 & eri1) where eri1 is a standby interface.
~ In the MultiPathing /etc/default/mpathd configuration  file, I set the
~ parameter FAILBACK to no.
~ So, no automatic Failback when a repair is detected.
~ Can anybody tell me how to failback manualy whithout 
~ rebooting the system ?
~ 
~ Thanks in advance.
~ _______________________________________________
~ SunHELP maillist  -  SunHELP at sunhelp.org
~ http://www.sunhelp.org/mailman/listinfo/sunhelp
~