[SunHELP] "ndd -get ..."

[Gallagher, Tim]

When I try any of these commands on a 2.8 system, I get;

          "couldn't push module 'hme', No such device or address"

Even though /dev/hme shows up in a listing.

Any thoughts on what might be going on there?


-----Original Message-----
From: Pissey, Vinod [mailto:Vinod.Pissey at compaq.com]
Sent: Monday, April 02, 2001 9:37 AM
To: 'sunhelp at sunhelp.org'
Subject: [SunHELP] RE: SunHELP digest, Vol 1 #928 - 17 msgs


Hi Triyono

You can use  the following command to find out the status of your network
card'

ndd -get /dev/hme link_speed  -----> will give you the speed of the network
card.
ndd -get /dev/hme link_status -----> will give  you the status whether up or
down.
ndd -get /dev/hme link_mode -------> will tell you whether it is half duplex
or full duplex.

You can use  the set command to set the network card to whatever you need.

Thanks
Regards
Vinod