[SPARCbook] SPARCbook 2 SCSI port

[Ken Hansen]

SCSI ID... I'll bet your CD-ROM is not set to ID 6...

Just a thought...

Ken
n2vip at bellatlantic.net

----- Original Message -----
From: "Robert D. Mohr" <robmohr at earthlink.net>
To: <sparcbook at sunhelp.org>
Sent: Wednesday, May 10, 2000 12:11 AM
Subject: [SPARCbook] SPARCbook 2 SCSI port


> I am attempting to set up an external CDROM (Toshiba XM-5401B Sun
bootable)
> for use on my SPARCbook 2.  With the SCSI adapters and cables I had laying
> around I was able to connect the two together, but the SPARCbook reports a
> SCSI failure on boot up when the cables are connected.  I suspect that the
> pinot of the SCSI port on the SPARCbook does not match the wiring of the
> cables I have.  Is it wired "normal" or differential?
>
> Does anyone have a pin out diagram for the SPARCbook 2?  Or perhaps a
wiring
> diagram for a cable that is known to work?  As a last resort, could
someone
> point me to a vendor that supplies cables that will work with the
SPARCbook?
>
> Thanks in advance for your assistance,
>
> Rob Mohr
>
> _______________________________________________
> Sparcbook mailing list  -  Sparcbook at sunhelp.org
> http://www.sunhelp.org/mailman/listinfo/sparcbook
>