[rescue] Cisco Catalyst 5000 FDDI Software

[Dan Sikorski]

Zach Lowry wrote:
> On May 27, 2008, at 6:33 PM, Dan Sikorski wrote:
>> You have a newer supervisor and newer CatOS than I do, so I'm 
>> suprised that this doesn't just work for you.
>
> But likely an older version of the FDDI software on the FDDI module, 
> which is bundled separately from the Supervisor software. Could you 
> send a 'show module' for your FDDI module?
>
Cat5k> (enable) show module
Mod Module-Name         Ports Module-Type           Model    Serial-Num 
Status
--- ------------------- ----- --------------------- --------- --------- 
-------
1                       2     100BaseTX Supervisor  WS-X5009  006342947 
faulty
2                       2     MM MIC FDDI           WS-X5101  007640097 ok
3                             Gigabit Ethernet Ext  WS-X5410  021230167
4                       9     Gigabit Ethernet      WS-X5410  021230167 ok
5                       24    10/100BaseTX Ethernet WS-X5234  014589615 ok

Mod MAC-Address(es)                        Hw     Fw         Sw
--- -------------------------------------- ------ ---------- 
-----------------
1   00-10-1f-a6-18-00 to 00-10-1f-a6-1b-ff 2.3    2.2(2)     4.5(4)
2   00-e0-1e-e5-0b-35                      1.3    2.1        3.2(2)
4   00-e0-1e-7c-5a-18 to 00-e0-1e-7c-5a-23 1.2    4.2(5)     5.5(3)
5   00-d0-bc-03-8c-28 to 00-d0-bc-03-8c-3f 1.0    4.5(2)     4.5(4)

Mod SMT User-Data              T-Notify CF-St    ECM-St    Bypass
--- -------------------------- -------- -------- --------- -------
2   WorkGroup Stack            30       thru     in        absent
Cat5k> (enable)


    -Dan Sikorski