[rescue] Origin Node board question

[Steve Hatle]

My mail had flaked out from the list right after posting this- if anyone
responded, I didn't see it, so could you please reply again (off-list if
it's already been hashed out there)?

If there were no answers, then I guess I'll have to wing it <grin>

Steve


> From: Steve Hatle <shatle at nfldinet.com>
> Reply-To: The Rescue List <rescue at sunhelp.org>
> Date: Tue, 30 Nov 2004 10:02:39 -0600
> To: The Rescue List <rescue at sunhelp.org>
> Subject: [rescue] Origin Node board question
> 
> All,
> 
> On my new Origin2K, all the node boards had been pulled out before I got it.
> I checked them all to make sure the memory was in the right banks, etc.
> 
> I've looked at all the compression connectors, and they seem OK- not dirty,
> etc. 
> 
> My question is about re-installing the boards correctly. The boards had been
> slid back in, but the compression actuators and board ear screws were loose.
> I've not been able to find any info along the lines of do you tighten the
> compression actuators first, then the board ear screws, or vice versa? Also,
> how tight to the compression actuators need to be- finger tight, tight as
> possible by hand, some specific torque level or ?
> 
> TIA for any help,
> 
> Steve
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue