[rescue] Ultra 1 Creator 3D Problem

[Eric Dittman]

I just got a used Ultra 1 Creator 3D.  I installed memory and
plugged in a monitor, keyboard, and mouse.  When I turned it
on I got nothing on the display.  I then connected up a terminal
and disconnected the monitor, keyboard and mouse.  When I turned
the Ultra 1 on I got the following, over and over:

RED State Exception

TL=0000.0000.0000.0005 TT=0000.0000.0000.0010
   TPC=0000.0000.f000.4200 TnPC=0000.0000.f000.4204 TSTATE=0000.0044.5600.1500
TL=0000.0000.0000.0004 TT=0000.0000.0000.0010
   TPC=0000.0000.f000.4200 TnPC=0000.0000.f000.4204 TSTATE=0000.0044.5600.1500
TL=0000.0000.0000.0003 TT=0000.0000.0000.0010
   TPC=0000.0000.f000.4200 TnPC=0000.0000.f000.4204 TSTATE=0000.0044.5600.1500
TL=0000.0000.0000.0002 TT=0000.0000.0000.0010
   TPC=0000.0000.f000.0200 TnPC=0000.0000.f000.0204 TSTATE=0000.0044.5600.1500
TL=0000.0000.0000.0001 TT=0000.0000.0000.0010
   TPC=0000.0000.f000.3a00 TnPC=0000.0000.f000.3a04 TSTATE=0000.0044.5600.0400

I searched GoogleGroups and found that the RED State Exception
could be anything from bad memory to a bad system board.  Is
there any way to decode the message to see exactly what is bad?
-- 
Eric Dittman
dittman at dittman.net
Check out the DEC Enthusiasts Club at http://www.dittman.net/