[SunRescue] ss1000 questions

[David Rouse]

On 2/8/01 at 7:40 AM, Peter L. Wargo <pwargo at basenji.com> wrote:

>on 2/8/01 4:36 AM, David Rouse at david at rouseworld.org wrote:
>
>
>> Internal as in a total of eight HDs! I'm thinking that the HDs in the
tray
>> need to be cabled up through the SCSI <IN> or <OUT> ports (I'll look on 

....

>Yes, they wire through the external SCSI.  I think you can't use board 0,
it
>has to be another boards, or an Sbus adaptor... hang on... <flip, flip>
Yep,
>you need a FSBE/S card if you onlu have one system board, as it uses the
>on-board scsi of a SB if it can.  Also, you can't daisy chain them, and you
>should terminate 'em.

Okay, I've got a cable running from the <IN> port of the disk tray to a FSBE
on card 0 of the ss1000. I've got a terminator on the <OUT> port. When
booting from the CD-ROM I get this message:

Disconnected command timeout for Target 2.0

There is a 'WARNING:' with a device tree address that is the disk tray's
associated with that message (prints right before).

Am I right to assume that disk #2 on the tray is bad or headed that way? I
haven't tried to format any of the disks on the tray yet.

By the way, I tried cabling the tray to the motherboard's scsi port, but
then I got contention with the internal drives. So I guess that is all on
one bus.

Thanks for everyone's help and advice as I've tried to get this running.

-- 
David Rouse                            * Our World - Your World - RouseWorld
david at rouseworld.org                   * www.rouseworld.org