Installation Overview

Installing Red Hat Linux on an Alpha system is slightly more complex than installing Red Hat Linux on an Intel machine because a variety of Alpha machine architectures exist and many different models are supported. In general, the sequence of steps to a successful installation are:

  1. Create a kernel disk from the image available on the Red Hat Linux/Alpha CD.

  2. Create a MILO disk, if necessary.

  3. Create a RAM disk diskette, if you're doing an NFS, FTP or hard drive install.

  4. Load and run the Red Hat Linux/Alpha kernel, and boot into the Red Hat Linux installation program using either the SRM console or MILO.

    NotePlease Note
     

    If your system supports both the SRM console and MILO, using SRM is the preferred boot method, and is the boot method supported by Red Hat.

  5. Install the bootloader on a small partition on your machine.

Disk Space Required for Alpha Installations

For both MILO and SRM installations, you'll need a floppy drive: a 3.5 inch high density "A:" drive (/dev/fd0). (Optionally, most SRM installations can use the CD-ROM drive.)

Hard Drive Space: