| Red Hat Linux 6.2: The Official Red Hat Linux Reference Guide | ||
|---|---|---|
| Prev | Appendix A. General Parameters and Modules | Next |
Table A-3. SCSI Parameters
| Hardware | Module | Parameters |
|---|---|---|
| NCR53c810/820/720, NCR53c700/710/700-66 | 53c7,8xx.o | |
| AM53/79C974 PC-SCSI Driver Qlogic PCI-Basic | AM53C974.o | AM53C974=host-scsi-id, target-scsi-id,max-rate, max-offset |
| Most Buslogic (now Mylex) cards with "BT" part number | BusLogic.o | BusLogic_Options=option,option,… (See README.BusLogic in …drivers/scsi/) |
| NCR53c406a.o | ncr53c406a=io_port[, IRQ[, FASTPIO]] ncr53c406a io=io_port irq=IRQ fastpio=FASTPIO | |
| Advansys SCSI Cards | advansys.o | |
| Adaptec AHA 152x | aha152x.o | aha152x=io_base, IRQ, scsi_id, reconnect, parity |
| Adaptec AHA 1542 | aha1542.o | aha1542=io_base,buson,busoff,dmaspeed |
| Adaptec AHA 1740 | aha1740.o | |
| Adaptec AHA-274x, AHA-284x, AHA-29xx, AHA-394x, AHA-398x, AHA-274x, AHA-274xT, AHA-2842, AHA-2910B, AHA-2920C, AHA-2930/U/U2, AHA-2940/W/U/UW/AU/, U2W/U2/U2B/, U2BOEM, AHA-2944D/WD/UD/UWD, AHA-2950U2/W/B, AHA-3940/U/W/UW/, AUW/U2W/U2B, AHA-3950U2D, AHA-3985/U/W/UW, AIC-777x, AIC-785x, AIC-786x, AIC-787x, AIC-788x , AIC-789x, AIC-3860 | aic7xxx.o | aic7xxx=string |
| Data Technology Corp DTC3180/3280 | dtc.o | |
| DTP SCSI host adapters (EATA/DMA) PM2011B/9X ISA, PM2021A/9X ISA, PM2012A, PM2012B, PM2022A/9X EISA, PM2122A/9X, PM2322A/9X, SmartRAID PM3021, PM3222, PM3224 | eata.o | eata=port0,port1,port2,… options eata io_port=port0,port1,port2,… option=value |
| DTP SCSI Adapters PM2011, PM2021, PM2041, PM3021, PM2012B, PM2022, PM2122, PM2322, PM2042, PM3122, PM3222, PM3332, PM2024, PM2124, PM2044, PM2144, PM3224, PM3334 | eata_dma.o | |
| DTP EATA-PIO boards | eata_pio.o | |
| Future Domain TMC-16x0- based cards TMC-1800, TMC-18C50, TMC-18C30, TMC-36C70, Future Domain TMC-1650, TMC-1660, TMC-1670, TMC-1680, TMC-1610M/MER/MEX, TMC-3260 (PCI), Quantum ISA-200S, ISA-250MG, Adaptec AHA-2920A (PCI) (NOT AHA-2920C) | fdomain.o | fdomain=io_base, IRQ[, ADAPTER_ID] |
| NCR5380 and NCR53c400 cards | g_NCR5380.o | ncr5380=io_port,IRQ,dma ncr53c400=io_port,IRQ ncr5380 io=io_port irq=IRQ dma=dma ncr53c400 io=io_port irq=IRQ |
| GDT ISA/EISA/PCI Disk Array Controller | gdth.o | gdth=IRQ0,IRQ1,IRQ2,… options:values |
| IOMEGA MatchMaker parallel port SCSI adapter | imm.o | |
| Always IN2000 ISA SCSI card | in2000.o | in2000=setup_string:value in2000 setup_string=value |
| Initio INI-9X00U/UW SCSI host adapters | initio.o | |
| AMI MegaRAID 418, 428, 438, 466, 762 | megaraid.o | |
| NCR SCSI controllers with 810/810A/815/ 825/825A/860/875/876/895 chipsets | ncr53c8xx.o | ncr53c8xx=option1:value1,option2:value2,… ncr53c8xx="option1:value1 option2:value2…" |
| Pro Audio Spectrum/Studio 16 | pas16.o | pas16=port,irq |
| IOMEGA PPA3 parallel port SCSI host adapter | ppa.o | |
| Perceptive Solutions PSI-240I EIDE | psi240i.o | |
| QLogic Fast SCSI FASXXX ISA/VLB/PCMCIA | qlogicfas.o | |
| QLogic ISP2100 SCSI-FCP | qlogicfc.o | |
| QLogic ISP1020 Intelligent SCSI cards IQ-PCI, IQ-PCI-10, IQ-PCI-D | qlogicisp.o | |
| Seagate ST01/ST02 | seagate.o | controller_type=1 base_address=base_addr irq=irq |
| Future Domain TMC-885, TMC-950 | seagate.o | controller_type=2 base_address=base_addr irq=irq |
| Cards with the sym53c416 chipset | sym53c416.o | sym53c416=PORTBASE[,IRQ] sym53c416 io=PORTBASE irq=IRQ |
| Trantor T128/T128F/T228 SCSI Host Adapter | t128.o | |
| Tekram DC390 and other AMD53C974A based PCI SCSI adapters | tmscsim.o | tmscsim=ID,SPEED |
| UltraStor 14F/34F SCSI host adapters (14F, 24F, 34F) | u14-34f.o | u14-34f=io_port1,io_port2,… io_port10 u14-34f io_port=io_port1,io_port2, … io_port10 |
| UltraStor 14F, 24F, and 34F | ultrastor.o | |
| WD7000-FASST2,WD7000-ASC, WD7000-AX/MX/EX | wd7000.o | wd7000=IRQ,dma,io_port wd7000 io=io_port irq=IRQ dma=dma |
Here are some examples of these modules in use:
Table A-4. SCSI Parameters Configuration Examples
| Configuration | Example |
|---|---|
| Adaptec AHA1522 at port 330, IRQ 11, SCSI ID 7 | aha152x=0x330,11,7 |
| Adaptec AHA1542 at port 330 | bases=0x330 |
| Future Domain TMC-800 at CA000, IRQ 10 | controller_type=2 base_address=0xca000 irq=10 |
When a parameter has commas, make sure you do not put a space after a comma.