SOFTPAQ NUMBER: SP5315 PART NUMBER: 276022-453, 275332-451, 275333-451 FILE NAME: N/A TITLE: Diagnostics and Compaq Setup for Workstations VERSION: 10.20 Rev A for Diagnostics and 1.09 Rev A for Computer Setup for Workstations LANGUAGE: French CATEGORY: Workstations/Diagnostics-Setup PRODUCTS AFFECTED: Compaq Professional Workstation 5000, 5100, 6000 and 8000 OPERATING SYSTEM: N/A SYSTEM CONFIGURATION: N/A EFFECTIVE DATE: 03 December 1997 ELECTRONIC DISTRIBUTION ALLOWED: Yes SOFTPAQ UTILITY VERSION: 2.x SUPERSEDES: SP4981 DESCRIPTION: Creates three diskettes: - One diskette for Personal Computer Diagnostics - Two diskettes for Computer Setup for Workstations PC Diagnostics and Computer Setup for Workstations are both pre-installed on the Diagnostics Partition. The diskettes in this SoftPaq should be used to update these utilities on the Diagnostics Partition. They can also be used to restore the Diagnostics Partition if it has been destroyed. Both utilities can be run by pressing F10 when the cursor moves to the upper right corner of the screen during power-up or reboot. Or they can be run directly from these diskettes. Personal Computer Diagnostics contains programs that can test and inspect the state of Compaq Professional Workstations and their devices. Computer Setup for Workstations allows the user to configure security and power management settings as well as system resources (DMA, IRQ, I/O Ports, and Memory). HOW TO USE: 1. Obtain three (3) formatted 1.44 MB diskettes. 2. Download the SoftPaq to a directory on your hard drive and change to that directory. The file that is downloaded is an executable with a filename based on the SoftPaq Number above. 3. From that drive and directory, execute the SoftPaq file. You will be prompted when to place each of the three formatted 1.44 MB diskettes into a diskette drive to create the diskettes. Label them as follows, using the Version numbers given above: First Diskette -- Personal Computer Diagnostics Second Diskette -- Computer Setup for Workstations (Disk 1 of 2) Third Diskette -- Computer Setup for Workstations (Disk 2 of 2) 4. After the diskettes are created, you may delete the SoftPaq file downloaded in step 2 if you wish. 5. Power down your computer, place the Personal Computer Diagnostics diskette in Drive A:, and power up your computer. a. To create or upgrade the Diagnostics Partition, select Manage Diagnostics Partition from the Compaq Utilities menu, then select either Create or Upgrade Diagnostics Partition. You will be prompted on when to insert the two Computer Setup for Workstations diskettes. b. To run TEST or INSPECT from the diskette without upgrading the Diagnostics Partition, select either TEST or INSPECT from the Compaq Utilities menu. 6. To run Computer Setup from diskette without creating or upgrading the Diagnostics Partition, boot from the Compaq Setup for Workstations diskette number 1, and select Run Setup from the main menu. Copyright 1997, Compaq Computer Corporation. All rights reserved. Product names mentioned herein may be trademarks and/or registered trademarks of their respective companies