SOFTPAQ NUMBER: SP13991 PART NUMBER: N/A FILE NAME: 686J4.CAB TITLE: Professional Workstation AP550 and SP750 ROM Image for Remote ROM Flash VERSION: 686J4_v2.13 LANGUAGE: English CATEGORY: ROMPaqs DIVISIONS: Workstations PRODUCTS AFFECTED: Compaq Professional Workstation AP550 and SP750 OPERATING SYSTEM: N/A SYSTEM CONFIGURATION: N/A EFFECTIVE DATE: June 1, 2000 ELECTRONIC DISTRIBUTION ALLOWED: Yes SOFTPAQ UTILITY VERSION: 4.x PREREQUISITE: Remote Management Setup or System Software Manager (SSM) SUPERSEDES: SP13756 DESCRIPTION: Creates a cabinet file that contains a binary image for the v2.13 System ROM in the Professional Workstation AP550 and SP750. The CAB file is used by Remote Management Setup or System Software Manager (SSM) to flash the System ROM on target Workstations on a network. Enhancements/Fixes: - Corrects a condition that was not allowing the Targa 3000 video solution to be configured properly. - Corrects a condition that was not allowing the system to boot from a floppy disk if an LS-120 drive was configured as the primary floppy device. - Corrects a condition that was not allowing DPT Array controllers and embedded SCSI and IDE solutions to interact properly. - Added support for Intel Zeon processor stepping change A1. HOW TO USE: 1. Download the SoftPaq to a directory on your hard drive. The file downloaded is a self-extracting executable. 2. If using Remote Management Setup, execute the downloaded file and follow the on-screen instructions. The name of the extracted file is 686J4.CAB. If you are using System Software Manager (SSM), then place the entire executable into the SSM filestore. 3. Refer to the Remote Management Setup documentation or the System Software Manager documentation for instructions on creating a Remote ROM Flash job to flash the ROM on target Workstations across the network. Copyright 2000, Compaq Computer Corporation. All rights reserved. Product names mentioned herein may be trademarks and/or registered trademarks of their respective companies.