SOFTPAQ NUMBER: SP10758 PART NUMBER: N/A FILE NAME: SP10758.EXE TITLE: Single Point Solution User ROMPaq Firmware Upgrade Diskette for Compaq Proliant 6000/7000(P40) Servers VERSION: 12.07.99 Rev.A LANGUAGE: English CATEGORY: ROMPaq DIVISIONS: Systems PRODUCTS AFFECTED: Compaq Proliant 6000/7000(P40) Servers OPERATING SYSTEM: N/A SYSTEM CONFIGURATION: N/A PREREQUISITES: N/A EFFECTIVE DATE: December 20, 1999 ELECTRONIC DISTRIBUTION ALLOWED: Yes SOFTPAQ UTILITY VERSION: 2.1 SUPERSEDES: none DESCRIPTION: This release provides a Single Point Solution User ROMPaq diskette for the Compaq Proliant 6000/7000(P40) Servers. New Features - ROM P40 - Proliant 6000/7000 (12/07/1999) =================================================== Added NMI entries into the Advanced Congifuration Power Interface tables. Added Linux support. Problems Fixed - ROM P40 - Proliant 6000/7000 (12/07/1999) =================================================== ACPI apic tables size fixed. HOW TO USE: 1. Obtain a formatted 1.44 MB diskette. 2. Download the SoftPaq to a directory on your hard drive and change to that directory. The file that is downloaded is an excutable with the file name based on the Softpaq Number above(SP10758.EXE). 3. From that drive and directory, execute the downloaded file and follow the on-screen instructions. You will be prompted to insert the formatted diskette in a drive to create the diskette. SP10758[ENTER] 4. After the diskette is created, you may delete the downloaded file SP10758.EXE if you wish. 5. For installation instructions refer to ROMPaq Firmware Upgrade Instructions below. ROMPaq Firmware Upgrade Instructions 1. Insert the ROMPaq diskette into the bootable diskette drive. 2. Turn unit off, then back on, to boot from the ROMPaq diskette. 3. After the ROMPaq utility has scanned the system for installed and supported devices, a screen appears indicating the ROMPaq diskette version. Press Enter. 4. A list of images installed and supported by this version of the ROMPaq Firmware Upgrade diskette will then be displayed. Press Enter to select the desired image on the list. 5. After pressing Enter, the utility will check to see if there is a newer firmware image available on the diskette for the selected device. If a newer firmware image IS NOT available on the diskette, the utility will display a message indicating this. In this case, press Enter and skip to step 8 below. If a newer firmware image IS available on the diskette, the utility will prompt you to "Select an image". Normally, there will only be a single firmware image to select, so press Enter to select the firmware revision shown. 6. When the utility asks whether it is OK to reprogram the selected device(s), press Enter to proceed. IMPORTANT: Do not interrupt the Flash reprogramming process in any way, or the firmware on the device being programmed may be destroyed. **Do not turn off power** ** Do not remove or install hot-pluggable disk drives** 7. When the Flash process has completed, a message will be displayed. Press Enter to continue. (If an error occurs, contact Compaq Technical Support.) 8. The utility will ask you to confirm that you want to continue. Press Enter to continue. 9. When prompted, remove the ROMPaq diskette from the floppy drive and power cycle the system. Copyright 1999, Compaq Computer Corporation. All rights reserved. Product names mentioned herein may be trademarks and/or registered trademarks of their respective companies