SOFTPAQ NUMBER: N/A

PART NUMBER: N/A

FILE NAME: Adpahci.1.0.414.0-3842-Windows2000_2003.i686.zip

TITLE: HP Embedded SATA RAID Controller Driver for Windows 2000 Server/Windows Server 2003

VERSION: 1.0.414.0-3842

KEY FILE: 

LANGUAGE: English

CATEGORY: Driver - Storage Controller

DIVISION: N/A

OPERATING SYSTEM: Windows 2000 Server/Windows Server 2003

PREREQUISITES: N/A

EFFECTIVE DATE: 08/26/2005

ELECTRONIC DISTRIBUTION ALLOWED: YES

SOFTPAQ UTILITY VERSION: N/A

SUPERSEDES: N/A

SUPPORT SYSTEMS/DEVICES:
  ProLiant ML110 G3

  HP Embedded SATA RAID Controller

DESCRIPTION:
~~~~~~~~~~~~
This driver is used to provide binary driver modules that have been pre-built for Windows 2000 Server/Windows Server 2003 to enable the HP Embedded SATA RAID controller.


FIXES:
~~~~~~

KNOWN ISSUES:
~~~~~~~~~~~~~

ENHANCEMENTS:
~~~~~~~~~~~~~

INSTALLATION
------------
Installing the Driver in a New Windows System 
---------------------------------------------
In this scenario, you are installing the driver in a new system that has no operating system. To install the driver: 
1. Create a driver disk by copying the contents of the Smart Component to a floppy diskette. 
2. If creating an array, press Ctrl+A or F8 when prompted to enter the BIOS Setup utility. 
3. Press F6 when prompted to install a third-party driver. 
   Note: When F6 is active, a prompt appears at the bottom of the screen. Press F6 immediately—you only have 5 seconds. If you miss your chance, restart this Windows installation to complete it correctly. Otherwise, Windows will not recognize your controller. 
4. Insert the driver disk you created in Step 1 and wait until prompted to install a driver. 
5. Press S to specify that the driver is on the floppy disk, then press Enter. 
6. When the HP Embedded SATA RAID driver is found, press Enter. Follow the remaining on-screen instructions to complete your installation.

Installing the Driver in an Existing Windows System 
---------------------------------------------------
In this scenario, you are installing a driver in a system that already has a Windows operating system. To install the driver: 
1. Create a driver disk by exracting the contents of Smart Component to a floppy diskette. 
2. Start Windows. Windows launches the Found New Hardware Wizard, which searches for the controller driver. 
3. Insert the driver disk you created in Step 1, select the floppy disk drive as the source then click Next. 
4. If necessary, select the appropriate driver for your operating system. 
5. Click Next as needed to complete the controller installation. 
6. Remove the driver disk. 
7. If prompted, restart the computer.

Customer Service
---------------------------------------------------
For support, please send email to contact.hp@hp.com

Copyright 2005, Hewlett_Packard Development Company, L.P. Product names mentioned heren may be trademarks and/or registered trademarks of their respective companies.