[SunHELP] Problem install SunTrunking 1.3

Richard Skelton Richard.Skelton at infineon.com
Wed Sep 20 06:16:19 CDT 2006


Hi,
I am trying to install SunTruning 1.3 on a V490 running Solaris 9
# uname -a
SunOS brstb1 5.9 Generic_118558-28 sun4u sparc SUNW,Sun-Fire-V490
# cat /etc/release
                        Solaris 9 9/05 s9s_u8wos_05 SPARC
           Copyright 2005 Sun Microsystems, Inc.  All Rights Reserved.
                        Use is subject to license terms.
                            Assembled 04 August 2005
Patches from:-
Solaris 9 Recommended Patch Cluster
DATE: Jul/06/06

The package installed fine :-
root: ./install

Sun Trunking 1.3 Utility Installation.

Copyright 2003 Sun Microsystems, Inc.  All rights reserved.
Use is subject to license terms.

*** Checking for existing Sun Trunking 1.3 Utility packages...

*** Checking for supporting Ethernet drivers and patches...

This script is about to take the following actions:
- Install Sun Trunking 1.3 Utility packages.
- Install Gigabit Ethernet: 113361-06 required patch(es).



Press return to continue, or 'Q' followed by a return to quit:


*** Installing patch 113361-06 for Solaris 9...

Checking installed patches...
This patch is obsoleted by patch 112233-12 which has already
been applied to this system.

Patchadd is terminating.

*** Installing Sun Trunking 1.3 Utility packages...
Copyright 2003 Sun Microsystems, Inc.  All rights reserved.
Use is subject to license terms.
==================================================================
Please modify /etc/opt/SUNWconn/bin/nettr.sh to set up trunking
configuration.
Please create /etc/hostname.qfeN entries for QFE trunk heads.
Please create /etc/hostname.geN entries for GEM trunk heads.
Please create /etc/hostname.ceN entries for CE trunk heads.
Reboot your system.

==================================================================

Installation of <SUNWtrku> was successful.
Copyright 2003 Sun Microsystems, Inc.  All rights reserved.
Use is subject to license terms.

Installation of <SUNWtrkm> was successful.
*** Done.
A log of this Install can be found at:
    /var/tmp/Trunking.install.2006.09.20

I checked the instance numbers for the ce interfaces:-
# grep ce /etc/path_to_inst
"/pci at 9,700000/network at 2" 0 "ce"
"/pci at 9,600000/network at 1" 1 "ce"
I then unplumbed the ce0 and ce1:-
# ifconfig -a
lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232 index 1
        inet 127.0.0.1 netmask ff000000
ce0: flags=1000863<UP,BROADCAST,NOTRAILERS,RUNNING,MULTICAST,IPv4> mtu
1500 index 2
        inet 172.29.216.232 netmask fffffe00 broadcast 172.29.217.255
        ether 0:14:4f:1e:81:f9
ce1: flags=1000862<BROADCAST,NOTRAILERS,RUNNING,MULTICAST,IPv4> mtu 1500
index 3
        inet 172.29.216.232 netmask fffffe00 broadcast 172.29.217.255
        ether 0:14:4f:1e:81:f9
# ifconfig ce0 unplumb
# ifconfig  ce1 unplumb
I then ran:-
# /etc/opt/SUNWconn/bin/nettr -setup 0 device=ce policy=1 members=0,1
Sep 20 11:31:33 brstb1 ce: NOTICE: ce_aggr_req: failed to register ce0 key=0
Sep 20 11:31:33 brstb1 trslm: NOTICE: trunk link (ce0): DL_ERROR_ACK for
DL_AGGR_REQ(259), errno 0, unix 0
/etc/opt/SUNWconn/bin/nettr: ioctl failed: I/O error
/etc/opt/SUNWconn/bin/nettr: UNLINK failed: Bad file number
/etc/opt/SUNWconn/bin/nettr: UNLINK failed: Bad file number
# /etc/opt/SUNWconn/bin/nettr -run
Configuring Sun Trunking devices
Sep 20 11:36:51 brstb1 ce: NOTICE: Trunk Setup failed
Sep 20 11:36:51 brstb1 ce: NOTICE: SLOW protocol stream bind failed
because Stream 3000cb922e0 sap 0x806 already bound to ce0 .. Exiting
Sep 20 11:36:51 brstb1 trslm: NOTICE: trunk link (ce0): DL_ERROR_ACK for
DL_BIND_REQ(1), errno 0, unix 0
nettr: ioctl failed: I/O error
nettr: UNLINK failed: Bad file number
nettr: UNLINK failed: Bad file number

I then rebooted to see if that would clear the problem:-
syncing file systems... done
Program terminated
{2} ok setenv local-mac-address? true
local-mac-address? =    true
{2} ok boot -r
Resetting ...


Software Reset

Enabling system bus....... Done
Initializing CPUs......... Done
Initializing boot memory.. Done
Initializing OpenBoot
Probing system devices
Probing I/O buses

Sun Fire V490, No Keyboard
Copyright 2005 Sun Microsystems, Inc.  All rights reserved.
OpenBoot 4.18.8, 16384 MB memory installed, Serial #69108217.
Ethernet address 0:14:4f:1e:81:f9, Host ID: 841e81f9.





Rebooting with command: boot -r
Boot device: /pci at 9,600000/SUNW,qlc at 2/fp at 0,0/disk at w21000014c3d2f418,0:a
File and args: -r
sorry, variable 'ecache_scan_rate' is not defined in the 'kernel'
SunOS Release 5.9 Version Generic_118558-28 64-bit
Copyright 1983-2003 Sun Microsystems, Inc.  All rights reserved.
Use is subject to license terms.
WARNING: forceload of misc/md_trans failed
WARNING: forceload of misc/md_raid failed
WARNING: forceload of misc/md_hotspares failed
WARNING: forceload of misc/md_sp failed
Configuring Sun Trunking devices
nettr: Cannot find /usr/lib/ld.so.1
Killed
configuring IPv4 interfaces: ce0.



What have I missed?


-- 



Cheers

Richard Skelton
Richard.Skelton at infineon.com
Infineon Technologies UK Ltd
Infineon House
Great Western Court
Hunts Ground Road
Stoke Gifford
Bristol
BS34 8HP
Tel +44(0)117 9528808



More information about the SunHELP mailing list