[SunHELP] Sun Ultra 2's, 300Mhz CPU's (#501-4849)

[Fred Dikeman]

Jumper J2301 needs to be changed from pins 2-3 (200/400MHz set up) to
pins 1-2 for 300 & 250MHz processors.

Fred Dikeman
 
Data Instruments, Inc
SUN-DEC-COMPAQ-HP Resellers
869 Pickens Industrial Drive
Suite 9
Marietta, GA 30062
800-466-1144  
770-919-2400
770-919-2004  fax
fred at workstation.net
 

-----Original Message-----
From: sunhelp-bounces at sunhelp.org [mailto:sunhelp-bounces at sunhelp.org]
On Behalf Of Ryan Loiselle
Sent: Wednesday, October 26, 2005 3:50 PM
To: The SunHELP List
Subject: [SunHELP] Sun Ultra 2's, 300Mhz CPU's (#501-4849)

Hello all..

Last winter I purchased 4x Sun Ultra 2's with single 200Mhz CPU's in
each
( CPU #501-4791), I have since removed the CPU's from 2 of the machines,
and installed them on the other 2 Chassies (leaving me with 2x Ultra 2's
with dual 200Mhz, 2x Ultra 2's with no CPU's). The two working machines
are not of relevence beyoned this point, but the 2 chassies with no
CPU's
are where my questions lie.

I have found a location that I can obtain 4x 300Mhz CPU's (#501-4849) in
order to begin using these empty chassie's and put them into production.

What are the mainbord part # / revision requirements for installing
these
dual 300's into these machines. The only documentation I can find gives
me
a part number if upgrading to 400Mhz CPU's (Sun Ultra 2 UltraSPARC-II
Module Upgrade PDF). There is also some info on:

http://sunsolve.sun.com/handbook_pub/Systems/U2/components.h tml

Under the Mainboard section @ the bottom:

Part # - Description
501-3132 - 200/300/400MHz
501-2487 - 200MHz (pre-FCS)

I am assuming that this last bit of information would be my guide, but I
just wanted to verify my findings befor I go out and spend a bunch of
cash
on CPU's...

Thanks!

Ryan Loiselle
ryan.loiselle at azonicnet.com

Personal:	www.azonicnet.com
Work:		www.seccuris.com
_______________________________________________
SunHELP maillist  -  SunHELP at sunhelp.org
http://www.sunhelp.org/mailman/listinfo/sunhelp