[SunHELP] break sent during connection to SC

[Dieter Montanez]

use "go" instead of "resume" to get out of the ok prompt.

Sometimes when you reboot a PC it will generate break
signal and if it is connected to the console port ... bang

dieter


-----Original Message-----
From: sunhelp-bounces at sunhelp.org [mailto:sunhelp-bounces at sunhelp.org]On
Behalf Of listmail at triad.rr.com
Sent: Wednesday, June 08, 2005 12:27 PM
To: sunhelp at sunhelp.org
Subject: [SunHELP] break sent during connection to SC


I connected to an V880 SC this morning through the serial port. It was 
already stupid that I chose to use hyperterm since you can't manually 
send a break, but somehow it sent a break anyway.  Either through 
having connected a cable or perhaps settings I chose which were 
9600,N,8,1.  Is there any explanation behind this?   I suppose setting 
the keyswitch to lock should prevent this in the future, but I flipped 
out to see our production box sitting at the ok prompt...  I 
tried "resume" but was getting FAST MMU miss so I had to reboot the 
box.  Thanks for any info.

FYI I've caught wind of TERATERM and i'm going to check that out, but I'
m still wary of connecting up through the serial port if a break is 
going to be sent and thus interrupt operations.  All I really need to 
do is dump the config and get the IP address that was originally 
configured in the SC for administrative telnet connections.
_______________________________________________
SunHELP maillist  -  SunHELP at sunhelp.org
http://www.sunhelp.org/mailman/listinfo/sunhelp