[SunHELP] Boot Problem with an E250

[Jim]

I am having a bit of a problem with a E250.

It was running fine for a while but was taken down in a power outage. 
It was on a UPS, so there should have been no power spike or anything 
hitting it. It had been running just fine for a few months from the 
last system change.

Now, it just hangs on boot:

-=-=-=-=-

Can't open input device.
Keyboard not present.  Using ttya for input and output.

Sun (TM) Enterprise 250 (2 X UltraSPARC-II 296MHz), No Keyboard
OpenBoot 3.12, 2048 MB memory installed, Serial #11124870.
Ethernet address 8:0:20:a9:c0:86, Host ID: 80a9c086.

Boot device: disk1:a  File and args:
SunOS Release 5.9 Version Generic_112233-11 64-bit
Copyright 1983-2003 Sun Microsystems, Inc.  All rights reserved.
Use is subject to license terms.
Type  'go' to resume
{0} ok boot cdrom
Resetting ...

Can't open input device.
Keyboard not present.  Using ttya for input and output.

Sun (TM) Enterprise 250 (2 X UltraSPARC-II 296MHz), No Keyboard
OpenBoot 3.12, 2048 MB memory installed, Serial #11124870.
Ethernet address 8:0:20:a9:c0:86, Host ID: 80a9c086.

Rebooting with command: boot cdrom
Boot device: /pci at 1f,4000/scsi at 3/disk at 6,0:f  File and args:
SunOS Release 5.9 Version Generic_112233-03 64-bit
Copyright 1983-2002 Sun Microsystems, Inc.  All rights reserved.
Use is subject to license terms.
-

-=-=-=-=-

As you can see, I tried booting off of a install CD as well incase 
there was something wrong with the hard drive. I have made sure all the 
boards are seated, etc. Nothing is lose, and the case is on all the 
way. I gave it plenty of time (overnight) on a normal boot to make sure 
I was not just being impatient. Also, boot disk is "disk1", but I tried 
booting up off of disk0-disk6 just for the hell of it. The CD not 
letting me boot is what really through me.

Anyone have any suggestions on where I should look on this?

Thanks
Jim
jameso at elwood.net