[SunHELP] Hardware or Tape

[Kovalev, Ivan]

It is the device, not the tape. Check the cabling all the way on the chain
where tape drive is, make sure chain is terminated properly.

-----Original Message-----
From: Katsuyoshi Charles M. Civ PACAF AIS
[mailto:Charles.Katsuyoshi at hickam.af.mil]
Sent: Wednesday, March 21, 2001 1:49 PM
To: 'sunhelp at sunhelp.org'
Subject: [SunHELP] Hardware or Tape


I have been trying to restore a disk on an Ultra 60 from a 0 level dump.  My
problem is that I get an error and I am not sure if the tape is bad or if my
tape drive is bad.  I get the following error:

Warning: /pci at 1f,4000/scsi at 3 (glm0):
	SCSI bus DATA IN phase parity error
Warning:/pci at 1f,4000/scsi at 3 (glm0):
	Target 4 reverting to async. mode
Warning:/pci at 1f,4000/scsi at 3/st at 4,0 (st4):
	SCSI transport failed:reason 'tran_err':giving up

Read error while restoring ./filename
continue[yn]
(if y is selected)
Read error while trying to resynchronize
continue[yn]
(if n is selected here)

Warning:/pci at 1f,4000/scsi at 3/st at 4,0 (st4):
	Error for command : space                    Error level:fatal
	Requested Block:(different every time)    Error block:(different
every time)
	Vendor:Exabyte
	Sense key:unit attention
	ASC:0x29 (power on, reset, or bus reset occurred, ASCQ:0x0, FRU:0x0

Any suggestions or tips would be greatly appreciated

Charles



 <<Charles M. Katsuyoshi (E-mail).vcf>>