[SPARCbook] RE: 3000XT PCMCIA cdrom problem

[Martin Marshall]

Jason:

Try connecting the CDROM to the scsi port on the SPARCbook.  Do not use
the PCMCIA card.  Set up the CDROM as Ken describes.

HTH,
Martin

Jason King wrote:
> 
> Ken,
>         Just posted what the configuration was and what I have done so far.  Hope
> it gives some insite to the problem.  Remember, this is a PCMCIA PANASONIC
> KXL-D740 cdrom drive with the PCMCIA card, and is noted in plain black and
> white in the pamplet I mentioned that came with this SPARCbook originally.
> My guess was, that being they talk about it, that is should work plain and
> simple.  But, I must be doing something wrong.
> 
> Jaosn King
> 
> > Here we go:
> 
> >    CD-ROM has to support 512 byte block size.
> >    CD-ROM has to attach to the *on board* SCSI connector.
> >    CD-ROM has to be set to SCSI ID #6
> >    CD-ROM needs good, dependable power (not on batteries, if applicable)
> >    The SCSI chain needs to be terminated, prefer "active" termination.
> 
> > Given all that, you should be able to simply power on the unit, get to the
> > OpenBoot prompt "ok>", and then issue "boot cdrom".
> 
> > If that doesn't work, then reset the NVRAM contents to default (check
> "help"
> > info for OpenBoot monitor by typing "help" at "ok>" prompt) and try again.
> 
> > If youa re still stuck, describe your ocnfiguration in detail.
> 
> >HTH,
> 
> >Ken
> 
> _______________________________________________
> Sparcbook mailing list  -  Sparcbook at sunhelp.org
> http://www.sunhelp.org/mailman/listinfo/sparcbook