[rescue] Sun 4/110 mainboard ejector?

[Dave McGuire]

  That is just *amazing*.  It's definitely a good time to be alive!

           -Dave

On 09/17/2015 10:41 PM, rjtoegel wrote:
> MIT has one that prints in glass.  Won't be long now.
> 
> Bob
> 
> Dave McGuire <mcguire at neurotica.com> wrote:
> 
>> On 09/17/2015 05:16 PM, Mike Meredith wrote:
>>>>   I have somewhat of a too-intimate knowledge of how the Sun VME
>>>> ejectors behave.  I'm quite certain neither an ABS nor a PLA printed
>>>> part will withstand that much pressure.
>>>
>>> However I suspect that a titanium printed part might hold up for a
>>> while.
>>
>>  My 3D printer doesn't print in titanium...does yours? ;)  (if so, can
>> I send you some files? ;))
>>
>>               -Dave
>>
>> -- 
>> Dave McGuire, AK4HZ
>> New Kensington, PA
>> _______________________________________________
>> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> 


-- 
Dave McGuire, AK4HZ
New Kensington, PA