[rescue] Sun 4/110 mainboard ejector?

[Joshua Snyder]

I was thinking about this more, Shapeways.com also prints in stainless 
steel.  If we had a good model we could get them to print a few.  It's 
$6 per part and $5 per cubic cm.  Just a thought.

-- 
Joshua Snyder
ISis ImageStream Internet Solutions, Inc.
4374 FM 1518, Selma, TX 78154, USA
Ph.  +1-210-569-1211 Ext. 104
Josh at ImageStream.com
www.ImageStream.com

On 9/17/15 4:41 PM, rjtoegel wrote:
> MIT has one that prints in glass.  Won't be long now.
>
> Bob
>
> Dave McGuire <mcguire at neurotica.com> wrote:
>
>> On 09/17/2015 05:16 PM, Mike Meredith wrote:
>>>>    I have somewhat of a too-intimate knowledge of how the Sun VME
>>>> ejectors behave.  I'm quite certain neither an ABS nor a PLA printed
>>>> part will withstand that much pressure.
>>> However I suspect that a titanium printed part might hold up for a
>>> while.
>>   My 3D printer doesn't print in titanium...does yours? ;)  (if so, can
>> I send you some files? ;))
>>
>>                -Dave
>>
>> -- 
>> Dave McGuire, AK4HZ
>> New Kensington, PA
>> _______________________________________________
>> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue