[rescue] E4000 installation

[Michael Vergallen]

This board was there only because it made sense to me to install it there so I would have all the connectors close toegther...so I can hook the terminal or monitor up witthout having to   
because the wait of the boards make them better suited ffor those locations...probably  during it's transit the cdrom drive failed...but okey no problem will just replace the drive.

Michael

> -----Original Message-----
> From: rescue-bounces at sunhelp.org 
> [mailto:rescue-bounces at sunhelp.org]On Behalf Of Patrick Finnegan
> Sent: Wednesday, June 08, 2005 7:02 AM
> To: The Rescue List
> Subject: Re: [rescue] E4000 installation
> 
> 
> Michael Vergallen declared on Tuesday 07 June 2005 09:37 pm:
> > Anyone know how to open the E4000 so I can check that the CDROM Drive
> > is connected ? That's the only bit I didn't remove while I was moving
> > the system.
> >
> > Regards,
> 
> You need the I/O board in slot 1 (the slot directly below the clock 
> card/serial ports), otherwise the SCSI bus on it won't connect to the 
> onboard SCSI peripheral bays.
> 
> Pat
> -- 
> Purdue University ITAP/RCAC       --- http://www.rcac.purdue.edu/
> The Computer Refuge               --- http://computer-refuge.org
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> 
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.323 / Virus Database: 267.6.5 - Release Date: 6/7/2005
> 
-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.6.5 - Release Date: 6/7/2005