[rescue] E4000 installation

[Michael Vergallen]

Anyone know how to open the E4000 so I can check that the CDROM Drive is connected ? That's the only bit I didn't remove while I was moving the system.

Regards,

Michael

> -----Original Message-----
> From: rescue-bounces at sunhelp.org 
> [mailto:rescue-bounces at sunhelp.org]On Behalf Of Michael Vergallen
> Sent: Wednesday, June 08, 2005 4:04 AM
> To: The Rescue List
> Subject: Re: [rescue] E4000 installation
> 
> 
>  I'm using a serial console it gets me to the ok prompt now since 
> I switched to a serial console but afterwards I'm stuck ... also 
> I think the cdrom drive is dead because it doesn't appear as a 
> device in showdevs. 
> And the system dousn't have narrow scsi to test with an external 
> drive...so I'm stuck.
> 
> Michael
> 
> > -----Original Message-----
> > From: rescue-bounces at sunhelp.org 
> > [mailto:rescue-bounces at sunhelp.org]On Behalf Of Patrick Giagnocavo
> > Sent: Wednesday, June 08, 2005 3:43 AM
> > To: The Rescue List
> > Subject: Re: [rescue] E4000 installation
> > 
> > 
> > On Wed, Jun 08, 2005 at 03:11:24AM +0200, Michael Vergallen wrote:
> > > I'm asking this because the maintenance led is blinking on both 
> > the cpu boards whereever I put them...what is the possible cause 
> > of that. Also the memory on the cpu boards are sitting wierd e.i. 
> > only half the banks are filled on each board. e.i. I have 2 Giga 
> > of memory 
> > > but only 1/2 the memory sockets on board one is filled and the 
> > same on board two also what is the sequence they should be installed ?
> > > 
> > > Michael
> > 
> > I think you can pretty much put the boards in any order...
> > 
> > You have 1GB in each board, and 2 boards = 2GB RAM.
> > 
> > The every-other RAM placement is because you can have 2 way memory
> > interleave on each board, giving you greater memory bandwidth.
> > 
> > What error messages are you getting?  Do you have a monitor and
> > keyboard plugged in or are you using a serial console?
> > 
> > --Patrick
> > _______________________________________________
> > rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> > 
> > -- 
> > No virus found in this incoming message.
> > Checked by AVG Anti-Virus.
> > Version: 7.0.323 / Virus Database: 267.6.4 - Release Date: 6/6/2005
> > 
> -- 
> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.323 / Virus Database: 267.6.4 - Release Date: 6/6/2005
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> 
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.323 / Virus Database: 267.6.4 - Release Date: 6/6/2005
> 
-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.6.4 - Release Date: 6/6/2005